Click here for more information
Click here for more information
Click here for more information |
BlueLEX GT-1200
Special Features:
Three light output modes:
1. Full Power (1000~1200 mW/cm2)
2. Ramp (soft start)
3. Pulse (full & half power shift)
-
Three pre-programmed of re-set memory: M1, M2& M3
-
Adjustable time setting (1-90 sec)
-
Memory free Li-on battery energy can be used continuously for 50 minutes after charging
-
Battery energy display
-
A built-in radiometer
-
A built-in magnetic fan motor
-
Polymerize wide range resin composites, compomers, adhesives, glass ionomers and enable to use on whitening cosmetic treatment and brace cement of orthodontic practice
-
Turbo tip
|
Click here for more information
|
BlueLEX LD-105
Special Features:
-
The cordless and ergonomic form gives the user full freedom of motion for optimal curing results, at full power ( 600~800 mW/cm2)
-
The elegant and simple design of one-touch functionality requires only minimal maintenance.
-
Its special high-performance Diode light emitter can polymerize an average 3mm thickness of material within 10 seconds on almost every resin-based composite in the market.
-
Its built-in high-density memory free rechargeable Lithium-ion battery can continuously carry out work sessions for over 40 minutes continuously per each recharge.
-
Glass tip
 (A) TIME:
Power on: Press to turn on the operating panel
Reset: Press and hold down the button to reset the cure time.
(B) START / STOP:
Press once to reset the curing cycle with countdown timer on the display. |
